Nikon SB-16 - Page 7

BASIC OPERATlON-------------
1 Set the open/closed knob
• ® on the flash unit coupler
to the OPEN position.
2 Attach the flash unit
. coupler to the flash unit.
Po si tion t he fl as h un it a nd flash unit
coupler, so
th at t he secondary f la sh
head
® on the flash un it a nd the s en -
sor
(J) on th e flash unit coupler fa ce
the same direc
ti on. In sert th e po si -
ti
on ing claw @ into the s lo t ® on th e
flash unit.
Then, while applying pressure to the
open/closed knob, push the flash
unit coupler into the flash unit until
it
clicks into place.
Note: If batteries ha ve already been installed in
the battery chamber, make su re the ON/OFF
switch
® is at the "o ff" position to avoid a cci -
dental firing.
7