29
Filter alarm
From factory, the filter alarm has been set to signal filter replacement every 90 days. You can set the timer to fit the level of pollution
in the area where the ventilation unit has been installed.
If someone in the household has pollen allergies, it is recommended that you install a pollen filter in the outdoor air intake.
> Filter alarm
Temperature control
The unit can cool the dwelling by means of bypass cooling and/or active cooling via the heat pump. The unit will only switch to cooling
mode if it is operating in summer mode, or if you have activated Cooling in “Operating function”.
> Temp. control
ATTENTION
It is important to change the filters regularly and when needed. Dirty filters reduce the efficiency of the ventilation unit
and result in a poorer indoor climate and higher power consumption.
> Days to change Settings:
Standard setting:
Description:
None /30 / 60 / 90 / 180 / 360
90 days
The number of days between filter changes can be set as
required.
> Summer/winter mode Settings:
Standard setting:
Description:
5 30 °C
12 °C
Here you set the temperature for the shift to and from summer
and winter mode.
• If the outdoor temperature is higher, the unit will operate in
summer mode.
• If the outdoor temperature is lower, the unit will operate in
winter mode.
To Next Page
Loading...
Need help?
General
