VHT37EXP
02/2013
5
C397
US
Packing and unpacking
Dispose of the packing materials in compliance with the laws
in force.
Figure 2
MODEL
VHT37EXP
A
in.
(mm)
B
in.
(mm)
C
in.
(mm)
lbs.*
(kg)
13 gal.
(25 L)
53.1
(1350)
27.6
(700)
71.1
(1805)
452.1
(205)
26 Gallons
(100 L)
53.1
(1350)
27.6
(700)
71.1
(1805)
458.1
(208)
* Weight with packaging
Unpacking, moving, use and storage
Operate on at, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight.
Setting to work - connection to the power
supply
WARNING!
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
■ Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the power supply
cords must be protected against splashes of water.
■ Check the proper connection to the electrical
mains.
■ Use the vacuum cleaner only when the cord
that connects to the electricity mains is in good
condition (damaged cords could lead to electric
shock!).
■ Regularly check there are no signs of damage,
excessive wear, cracks or aging on the electric
cord.
WARNING!
When the device is operating, do not:
■ Crush, pull, damage or tread on the cord that
connects to the electrical mains.
■ Only disconnect the cord from the electrical mains
by removing the plug (do not pull the cord).
■ Only replace the power supply cord with one of the
same type as the original: SOOW. The same rule
applies if an extension is used.
■ The cord must be replaced by the manufacturer’s
Service Center staff or by equivalent qualied
personnel.
Warning labels
Figure 3
Labels:
1. Warning: Explosion proof plug installed shall be certied
and be suitable for the hazardous area that the vacuum
is installed in
2. Warning: To reduce the risk of electric shock - do not use
outdoor
Caution: Open circuit before removing cover and keep
covers tight while circuits are alive
Warning: Explosion hazard - use only Nilsk hose
Warning: The vacuum must be cleaned only with a damp
cloth