Ninja BL685 User Manual

Assembly and Use of the Pitcher
A WARNING : Handle the Stacked Blade Assembly with care, as the blades are sharp.
A WARNING : Remove utensils pr i or to processing. Failure to remove may cause the pitcher to be damaged or
to shatter, which may cause personal injury.
A WARNING : Never leave the appliance unattended while in use .
A CAUTION : Do not blend hot liquids, do i ng so may cause excess i ve pressure buildup, resulting in risk of the
user being burned.
IMPORTANT: Make sure that the motor base is plugged in for use .
ASSEMBLY
Fig. 1 Fig.2
Review warning and caution statements above before
proceeding to number 2.
2 Place the motor base on a clean, dry , level surface such
as a counter or table top.
3 Align and lower the pitcher onto the motor base .
(Fig. 1) Handle should be aligned slightly to the right of
the "LOCK" symbol on the motor base .
4
Rotate the pitcher clockwise until it locks in place . You
will hear a click when the lock is engaged . (Fig. 2)
5 The pitcher can be placed on the motor base two ways ;
the handle can be on the front right corner or the front
left corner . (F ig. 3a , Fig . 3b)
6 Holding the Stacked Blade Assembly by the top of the
shaft, place it onto the drive gear inside the pitcher .
Ensure that the Stacked Blade Assembly is seated
properly and is standing upright. (F ig. 4)
NOTE : The Stacked Blade Assembly will fit loosely on
the drive gear .
7
Add the ingredients to the pitcher, making sure that
they do not exceed the highest measured marking line
on the side of the pitcher .
5 I B? 1-877-646-5288
BL685_Series_lB_ 170428_press.indd 6
Fig. 4
I = ~I
i
Fig. 5
NOTE: If you need to add additional ingredients while
the appliance is processing , open the pour spout cap
and pour the ingredients in through the opening.
NOTE: When blending any kind of liquids, such as
mi x tures of any drinks or smoothies , do not ex ceed the
" Max liquid " mark (64 ounces) on the pitcher.
8 Plug the power cord into the electrical outlet and press
the power button (6).
IMPORTANT: As a safety feature , the power
button (6) will flash and the motor will not work
if the pitcher and lid are not i nstalled correctly .
When the pi tcher and lid are i nstalled properly ,
the power button (6) will be solid, indicating that
the appliance is ready for use.
9 Holding the lid by the handle in the upright position ,
place it on top of the pitcher aligning the arrow
('Y) located on the lid with the arrow (&) located on the
pitcher 's handle . (Fig. 5) Press the handle down until
you hear a click. The triangles on the lid and the pitcher
handle MUST be aligned in order for the blender to
turn on .
2017-05-01 9:08
AM I
Case 2:23-cv-02144 Document 1-1 Filed 03/20/23 Page 6 of 16 PageID #: 17

Ninja BL685 Specifications

General

Brand	Ninja
Model	BL685
Category	Blender
Language	English