Ninja BL700 - Using the Bowl

9
1-877-646-5288
USING THE DOUGH BLADE
IMPORTANT: Use only the “DOUGH” button when
using this attachment.
1 Place the motor base on a clean, dry, level surface such
as a counter or table top. (Fig. 11)
2 Secure the bowl onto the motor base.
3 Holding the dough blade by the shaft, place it onto the
gear shaft inside the bowl. Ensure that the attachment
fits around the gear shaft and that it is standing straight.
4 Add the ingredients and secure the bowl lid onto the
bowl. (Fig. 11)
NOTE:Forbestresultsaddwetingredientsrstand
then add dry ingredients.
5 Plug the power cord into the electrical outlet and press
on the power button (
).
NOTE: Please refer to “Speed Settings & Uses” chart
for suggested uses.
USING THE 4-BLADE ASSEMBLY
CAUTION: Blades are not locked in place. If using
the pour spout, ensure the lid is fully locked onto
the bowl.
CAUTION: Blades are not locked in place. If pouring
with the lid removed, ALWAYS remove the blade
assembly first.
1 Place the motor base on a clean, dry, level surface such
as a counter or table top. (Fig. 10)
2 Secure the bowl onto the motor base.
3 Holding the 4-Blade assembly by the shaft, place it
onto the gear shaft inside the bowl. Ensure that the
attachment fits around the gear shaft and that it is
standing straight.
4 Add the ingredients and secure the bowl lid onto the
bowl. (Fig. 10)
5 Plug the power cord into the electrical outlet and press
on the power button (
).
NOTE: Please refer to “Speed Settings & Uses” chart
for suggested uses and speeds.
Fig. 11
Using the Bowl
Fig. 10
WARNING: Never leave the appliance unattended while in use.
CAUTION: Handle the blade assemblies with care, as the blades are very sharp.
IMPORTANT: Make sure that the motor base is plugged in for use.