Ninja BL700 - Using the Pitcher

8
www.ninjakitchen.com
USING THE 6-BLADE ASSEMBLY
1 Holding the 6-Blade assembly by the shaft, place it
onto the gear shaft inside the pitcher. Ensure that the
attachment fits around the gear shaft and that it is
standing straight.
2 Add the ingredients and secure the pitcher lid onto the
pitcher. (Fig. 9)
3 Plug the power cord into the electrical outlet and press
on the power button (
).
NOTE: Please refer to “Speed Settings & Uses” chart
for suggested uses and speeds.
Using the Pitcher
Fig. 7 Fig. 9
8 To remove the container, press the power button ( ) to
turn the appliance Off. Wait for the attachment to stop
moving before removing. (Fig. 7)
9 Depending on the consistency of the contents in the
container, open the pour spout cap and use the spout
toemptyliquidcontents.Forthickerconsistencies,
remove the lid and attachment carefully (by its shaft),
then empty contents from the container.
CAUTION: Blades are not locked in place. If using
the pour spout, ensure the lid is fully locked onto
the blender pitcher.
10 Forthickerconsistencies,removethelidandblade
attachment carefully (by its shaft), then empty contents
from the container. To remove the lid, press the release
button on the lid and pull the lid handle up to a 90°
angle and lift the lid off the blender pitcher.
CAUTION: Blades are not locked in place. If
pouring with the lid removed, ALWAYS remove the
blade assembly first.
11 Make sure that the unit is unplugged when not in use.
12 To release the motor base from the counter or table top,
place your hands underneath both sides of the motor base
and gently pull the unit up and towards you. (Fig. 8)
Fig. 8