Ninja BL700 - Page 7

6
www.ninjakitchen.com
HOW TO ASSEMBLE
1 Place the motor base on a clean, dry, level surface such
as a counter or table top.
2 Lower the pitcher or the bowl onto the motor base.
(Fig. 1)
3 Rotate the container to the left as far as it will go. As
the container rotates, it will lower and the safety tabs
on the bottom of the container will slide under the
safety tabs on the top of the motor base. (Fig. 2)
4 The pitcher or bowl can be placed on the motor base
two ways; the handle can be on the front right corner or
the front left corner. (Fig. 3a, Fig. 3b)
5 Holding the desired attachment by the shaft, place it
onto the gear shaft inside the container. Ensure that
the attachment fits around the gear shaft and that it is
standing straight. (Fig. 4a, Fig. 4b)
HOW TO USE
1 Place the pitcher or bowl onto the motor base
and insert the desired attachment. (See HOW TO
ASSEMBLE.)
2 Add the ingredients to the container. Make sure your
total of ingredients don’t exceed the highest measured
marking line on the side of the containers.
NOTE: When blending any kind of liquids, such as
mixtures of any drinks or smoothies, do not exceed the
“Max liquid” mark (64 ounces) on the pitcher.
Fig. 4b
Fig. 1
Fig. 2
Fig. 3a
Fig. 3b Fig. 4a
WARNING: Never leave the appliance unattended while in use.
CAUTION: Handle the blade assemblies with care, as the blades are very sharp.
IMPORTANT: Make sure that the motor base is plugged in for use.