Getting Started
The Meter turns on automatically when a Test Strip
Contact End is inserted into the Test Port or when
is pressed (see Set Up and Memory).
The Meter turns off automatically after the Test
Strip is removed from the Test Port or after 2
minutes of non-use.
Meter comes with pre-set time and date. Before
using the Meter for the first time or after a battery
change, check the time and date and update as
needed (see Set Up).
The TRUEbalance is a no-coding system, which
means that the Meter does not have to be coded to
each lot of Test Strips.
13
TB_OB_GutsENG_H4IAU03.qxd:TT_OB_GutsENG.qxd 10/13/10 12:32 PM Page 13
To Next Page
Loading...
