Nokia 4G03-A - ESD Safety Guidelines

ANSI safety guidelines Nokia FastMile 4G Receiver Product Overview
24 3TG-00386-ABAA-TCZZA Issue: 01 DRAFT
DRAFT
Note — The Nokia FastMile 4G Receiver equipment complies
with the U.S. National Electrical Code. However, local electrical
authorities have jurisdiction when there are differences between
the local and U.S. standards.
4.3.1 Power supplies
The use of any non-Nokia approved power supplies or power adapters is not
supported or endorsed by Nokia. Such use will void any warranty or support contract
with Nokia. Such use greatly increases the danger of damage to equipment or
property.
4.3.2 Cabling
The following are the guidelines regarding cables used for the Nokia FastMile 4G
Receiver equipment:
• All cables must be approved by the relevant national electrical code.
• Cables for outdoor connection to the Nokia FastMile 4G Receiver equipment
must be suitable for outdoor use.
• The Nokia FastMile 4G Receiver equipment must be used with the cabling
supplied with the equipment.
4.3.3 Protective earth
Earthing and bonding of the Nokia FastMile 4G Receiver equipment must comply
with the requirements of NEC article 250 or local electrical codes.
4.4 ESD safety guidelines
The Nokia FastMile 4G Receiver equipment is sensitive to ESD if opened.
Operations personnel must observe the following ESD instructions when they
handle the Nokia FastMile 4G Receiver equipment.
Caution — This equipment is ESD sensitive if opened. Proper
ESD protections should be used if you open the Nokia FastMile
4G Receiver.