7368 ISAM ONT E-240W-A Product Guide E-240W-A unit data sheet
Issue: 01 3FE-46974-AAAA-TCZZA 49
4.9.1.2 Wi-Fi standards and certifications
The Wi-Fi service on E-240W-A indoor ONTs supports the following IEEE standards
and Wi-Fi Alliance certifications:
• certified for IEEE 802.11ac/b/g/n/standards
• WPA support including WPA-PSK
• certified for WPA2-Personal and WPA2-Enterprise
4.9.1.3 Wi-Fi GUI features
E-240W-A indoor ONTs have HTML-based Wi-Fi configuration GUIs.
4.9.2 E-240W-A ONT considerations and limitations
Table 10 lists the considerations and limitations for E-240W-A ONTs.
Table 10 E-240W-A ONT considerations and limitations
Considerations and limitations
Call History Data collection (ONTCALLHST) is supported, except for the following parameters:
RTP packets (discarded), far-end RTCP and RTCP-XR participation, RTCP average and peak round trip delay,
MOS, average jitter, number of jitter-buffer over-runs and under runs.
Some voice features are configurable on a per ONT basis, including Call Waiting, Call Hold, 3-Way Calling, and
Call Transfer.
The following voice features / GSIP parameters are configurable on a per-Client/ per-ONT basis (not
per-Subscriber):
• Enable Caller ID and Enable Caller Name ID
• Digitmap and the associated Interdigit and Critical timers and Enter key parameters
• Warmline timer is enabled per subscriber, but the warmline timer value is configured per ONT and must
have a lower value than the Permanent time
• Miscellaneous timers: Permanent, Timed-release, Reanswer, Error-tone, and CW-alert timers
• Features / functions: Message waiting mode, WMWI refresh interval, DTMF volume level
• Service Codes for the following features: CCW, Call Hold and Warmline
Release 06.00.00h | January 2019 | Edition 08
To Next Page
Loading...
