178
Nokia A032 Advanced User Guide
The next section gives a more detailed
explanation of the above error messages.
info LED error codes explained
100001: Bad code image
This error message indicates that the flash
memory firmware is invalid or corrupted.
Correct firmware is loaded at the factory prior
to shipment. Therefore this problem may be the
result of a problem during an upgrade
procedure. Appendix G describes methods for
reloading the firmware. If these procedures fail
to solve the problem there may be a failure in
the unit and it may need to be repaired.
Code Meaning Log text
100001 Bad code image <none>
110000 Bad PCMCIA hardware PCMCIA hardware failure
110001 No PCMCIA No PCMCIA card detected
110010 Bad PCMCIA card Non-compatible PCMCIA card
110011 Bad radio (does not initialize) Cannot initialize radio
110100 Bad firmware version Incorrect firmware version
001000 Bad DRAM (stuck address) Memory error type 1
001001 Bad Ethernet RAM (stuck address) Memory error type 2
001010 Bad CMOS Memory Configuration error — default
loaded
101000 LAN controller error LAN Interface Error
011000 Bad configuration Configuration error
011001 Bad Manufacturer's info Bad unit checksum
011010 Bad log sector Log sector bad — recovered
011011 System error System fault
A032-Adv.book Page 178 Monday, November 13, 2000 10:47 AM
To Next Page
Loading...
Need help?
General
