70
Nokia A032 Advanced User Guide
Using the CLM ‘set’ command
There are many commands available from the
CLM. This section discusses the
set command
and its associated parameters, which you can
use to configure the
Nokia A032. For a
complete list of available commands, see CLM
commands on page 90.
The procedure for entering commands to
configure the Nokia A032 is the same, whether
you’re using a Telnet session or a terminal
emulator via the serial port.
The basic command syntax is:
set parameter value
The format of value depends on the parameter
you’re setting. Some values are simple
numbers, some are strings and some are special
values such as IP addresses.
For a full list of parameters and their associated
values, see Optional parameter summary on
page 71 and Default value ‘set’ parameter
descriptions on page 74.
To see a list of all available set parameters,
enter the following:
set help
or
set ?
A032-Adv.book Page 70 Monday, November 13, 2000 10:47 AM
To Next Page
Loading...
Need help?
General
