Nokia A032 User Manual

Command line interface
71
Optional parameter summary
The following table gives a complete list of the
parameters available when using the
set
command. After the table an explanation of
each parameter is given. In most cases you’ll
need to restart the unit in order for the change
to take effect (the CLM will prompt you to do
this when necessary).
If you are changing the parameters remotely
you can initiate a restart using the CLM
restart command.
Parameter Function
Radio-related
channel Sets radio frequency channel
domain Regulatory domain
rts_threshold IEEE802.11 parameter
short_retry IEEE802.11 parameter
long_retry IEEE802.11 parameter
sifs_time IEEE802.11 parameter
frag_threshold IEEE802.11 parameter
basic_rate Sets the 802.11 basic rate set
Access Point functions
net_name Logical name of wireless network
ap_name Identifier name for access point
protocols Selects protocol filtering
TCP/IP parameters
ip_address Sets IP address of Nokia A032
subnet_mask Sets Subnet Mask for local network
gateway Sets Default Route when TCP/IP filtering
A032-Adv.book Page 71 Monday, November 13, 2000 10:47 AM

Nokia A032 Specifications

General

Brand	Nokia
Model	A032
Category	Wireless Access Point
Language	English