Nokia A032 User Manual

Command line interface
87
Modem setup
Parameter
Description Default
mdm_speed Specifies the data rate used to communicate
between the Nokia A032 and a modem. Note that
this is not necessarily the rate that the modem will
support when it communicates to the ISP. Generally
the modem will not connect at a speed higher than
this rate but it may connect at a speed which is
lower.
Valid values: 9600, 19200, 38400, 57600, 115200.
57600
(bps)
mdm_init Use this to specify any special AT commands
necessary to set your modem in the correct mode
(only older modems require this – most modems
work in their default mode with the Nokia A032.)
See the modem’s manual or contact Nokia Technical
support.
(empty)
mdm_holdtime Sets the number of minutes for which the link
needs to be inactive before the connection is broken
and the modem disconnected. A value of zero
indicates that the modem will remain connected
indefinitely.
3 (minutes)
Internet Gateway
A032-Adv.book Page 87 Monday, November 13, 2000 10:47 AM

Nokia A032 Specifications

General

Brand	Nokia
Model	A032
Category	Wireless Access Point
Language	English