Startup problems
177
Startup problems
This section gives advice on troubleshooting
problems during initialization (startup).
Initialization error codes
If the initialization procedure fails an error
code should be displayed on the
info LEDs and
the
alert LED will remain on.
The code should be read from left to right. To
identify the code write down each LED as a '1'
or '0' depending on its state (on = 1).
For example the pattern:
on on off off on off
would be written:
110010
The following table shows the meaning of the
initialization error codes.
Note: If the unit fails
to perform the
initialization
sequence, it may need
to be repaired. In this
case contact your
supplier for support.
A032-Adv.book Page 177 Monday, November 13, 2000 10:47 AM
To Next Page
Loading...
