194
Nokia A032 Advanced User Guide
You’ll see the Nokia Access Point Upgrade
utility window:
Initially, you’ll see
Status: Access Point not ready
4 Select the correct Serial Port (e.g. COM1).
5 Switch off the Nokia A032.
6 Press and hold the
mode button and switch
the unit on again. Continue to hold the
mode button while the info LEDs all switch
on, then go off. This takes about five
seconds.
7 Keep holding the button until the
info LEDs
come on again. This happens about 5
seconds after they have gone off.
8 When the
info LEDs come on again, release
the button.
Assuming you have the correct serial cable and
COM port a message will appear in the Nokia
Steps 4-7: Restart the
Nokia A032 in BIOS
communication mode.
A032-Adv.book Page 194 Monday, November 13, 2000 10:47 AM
To Next Page
Loading...
Need help?
General
