Command line interface
77
Access point functions
Parameter Description Default
net_name String up to 32 characters specifying the network
name for the wireless LAN in Infrastructure mode.
Names which contain non-alphanumeric characters
or spaces must be enclosed in double quotes (for
example, “Nokia WLAN”).
Nokia
WLAN
ap_name String up to 15 characters used to give the Nokia
A032 a name. Useful if you have multiple access
points on a network for roaming (assign the same
network–name but a different ap_name to each
access point). This name is displayed in some of the
management commands.
LocalAP
protocols The default mode of the A032 is to pass all
protocols.
Some non-TCP/IP protocols issue frequent
broadcasts or multicast messages. These can use up
the available data bandwidth on the wireless LAN
and slow down response time. If your wireless
stations only use TCP/IP you can set the value of
protocols to TCPIP. In this case non-TCP/IP
messages are not passed by the access point. Note
that if your network uses BootP or RARP messages
you should select all for the protocol value.
all
A032-Adv.book Page 77 Monday, November 13, 2000 10:47 AM
To Next Page
Loading...
Need help?
General
