2. When Remove memory card? Some applications will be closed. is
displayed, select Yes.
3. When Remove memory card and press 'OK' is displayed, remove the back
cover of the device, and push the card in, until you hear a click.
4. Pull out the memory card, and replace the back cover. If the device is switched
on, select OK.
Charge the battery
Your battery has been partially charged at the factory, but you may need to
recharge it before you can switch on your device for the first time. If the device
indicates a low charge, do the following:
1. Connect the charger to a wall outlet.
2. Connect the charger to the device.
3. When the device indicates a full charge, disconnect the charger from the device,
then from the wall outlet.
You do not need to charge the battery for a specific length of time, and you can
use the device while it is charging. If the battery is completely discharged, it may
take several minutes before the charging indicator appears on the display or before
any calls can be made.
Tip: Disconnect the charger from the wall outlet when the charger is not in
use. A charger that is connected to the outlet consumes power even when it
is not connected to the device.
USB charging
You can use USB charging when a wall outlet is not available. Data can be
transferred while charging the device. The efficiency of USB charging power varies
significantly, and it may take a long time for charging to start and the device to
start functioning.
Get started
© 2010 Nokia. All rights reserved. 15
To Next Page
Loading...
Need help?
General
