Installing the FastMile 5G Receiver
24
User Guide
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3TG-02285-AAAA-TCZZA-02
Figure 15 Pressing the mounting sleeve to the glass
Slide the FastMile 5G Receiver into the mounting sleeve. Ensure that the signal test
button faces towards the inside of the room (the Nokia logo should face outside). The
FastMile 5G Receiver secures into place by clipping into the metal clip that is on the
bottom of the mounting sleeve.
For a FastMile 5G Receiver that is being mounted on the outside of a window, route
the pre-attached PoE cable of the FastMile 5G Receiver through the window seal
and into the room. If possible, make sure that there is enough slack in the pre-
attached PoE cable on the outside of the window to form a loop so that any water
that runs down the cable below the FastMile 5G Receiver will drip off the cable lower
than the window seal.
To Next Page
Loading...
