Installing the FastMile 5G Receiver
18
User Guide
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3TG-02285-AAAA-TCZZA-02
Follow the on-screen guidance provided by the Nokia Wireless Mobile App to find the
best location for the FastMile 5G Receiver.
The Nokia Wireless Mobile App will do an app-performed signal test, and might
recommend that you reposition the FastMile 5G Receiver based on the signal test
results. See Repositioning for a better signal for information about repositioning the
FastMile 5G Receiver.
The Nokia Wireless Mobile App can be used to do a speed test using Ookla.
Once you have finished using the Nokia Wireless Mobile App to determine the best
location for the FastMile 5G Receiver, you can finish off the installation:
• see Finishing off installation of the FastMile 5G Receiver on a window for
instructions on how to mount it on the outside or inside of a window
• see Finishing off installation of the FastMile 5G Receiver on a desktop stand for
instructions on how to place it on a desktop stand close to a window
Connecting the FastMile 5G Receiver to power
You can connect the FastMile 5G Receiver to power when:
• trying different locations
• confirming the final location
• finishing off the installation if the FastMile 5G Receiver is not already connected
to power
The FastMile 5G Receiver requires the supplied PoE injector and cables in order to
connect to power. The FastMile 5G Receiver starts up when it is connected to power
through the supplied PoE injector.
Details for connecting the FastMile 5G Receiver to the PoE injector depend on the
type of installation and on the kit:
• for kits for which the FastMile 5G Receiver comes with an ultra flat cable as the
pre-attached PoE cable, connection to the PoE injector will be through the
supplied PoE cable that you connect to the pre-attached PoE cable; the
following figure shows this type of installation
• for kits for which the FastMile 5G Receiver comes with a flat cable as the pre-
attached PoE cable, connection to the PoE injector will be directly through the
pre-attached cable; connectivity is similar to that shown in the following figure
except that no PoE cable is used for the connection to the PoE injector
To Next Page
Loading...
