Installing the FastMile 5G Receiver
26
User Guide
© 2022 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3TG-02285-AAAA-TCZZA-02
Figure 17 Example of cable clamp usage
If the FastMile 5G Receiver is not connected to power, connect it to power as
described in Connecting the FastMile 5G Receiver to power.
Secure the PoE injector in place as appropriate. It is recommended to install the PoE
injector so the POE/WAN port used for connecting the PoE injector to the FastMile
5G Receiver faces downwards. Be sure to allow for any required slack in the cabling
attached to the FastMile 5G Receiver.
Connect a 1 Gbps Ethernet LAN cable between the PoE injector and your gateway.
You will need to provide the cable if it was not supplied as part of the kit for the
FastMile 5G Receiver.
To Next Page
Loading...
