Copyright
©
2006 Nokia. All rights reserved.
Tools
101
WLAN netw. mode — Select Ad-hoc to create an ad hoc
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
WLAN security mode — Select the encryption used: WEP,
802.1x (not for ad hoc networks), or WPA/WPA2. If you
select Open network, no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the network
supports them.
WLAN security sett. — Enter the settings for the selected
security mode:
Security settings for WEP:
Wep key in use — Select the WEP key number. You can
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.
Authentication type — Select Open or Shared for the
authentication type between your device and the wireless
LAN access point device.
WEP key settings — Enter WEP encryption (length of the
key), WEP key format (ASCII or Hexadecimal), and WEP
key (the WEP key data in the selected format).
Security settings for 802.1x and WPA/WPA2:
WPA mode — Select the means of authentication: EAP to
use an extensible authentication protocol (EAP) plug-in, or
Pre-shared key to use a password. Complete the
appropriate settings:
EAP plug-in settings (only for EAP) — Enter the settings
as your service provider instructs.
Pre-shared key (only for Pre-shared key) — Enter a
password. The same password must be entered on the
wireless LAN access point device.
TKIP encryption — Select whether Temporal Key Integrity
Protocol (TKIP) is used.
Homepage — Define a home page.
Select Options > Advanced settings and from the
following:
IPv4 settings: Phone IP address (the IP address of your
device), Subnet mask (the subnet IP address), Default
gateway (the gateway), and DNS address — Enter the IP
addresses of the primary and secondary DNS server.
Contact your Internet service provider for these addresses.
IPv6 settings >
DNS address — Select Automatic,
Well-known, or User defined.
Ad-hoc channel (only for Ad-hoc) — To enter a channel
number (1-11) manually, select User defined.
Proxy serv. address — Enter the address for the proxy
server.
Proxy port number — Enter the proxy port number.
9247229_N93-1_en_Apac.book Page 101 Thursday, May 18, 2006 3:43 PM