Nokia N93 - Still Image Camera Settings

Copyright
©
2006 Nokia. All rights reserved.
Camera
24
The camera viewfinder displays the following:
• Status indicators
(1) for sequence
on, self-timer
on; Automatic
(), On (), or
Off () flash
mode, and the
current capture
mode.
• The toolbar (2),
which you can scroll through before capturing the
image to select the shooting mode, white balance,
exposure value, and color tone (the toolbar is not
displayed during focus and image capture).
• The image resolution indicator (3) indicates whether
the quality of the image is Print 3M - Large
(2048x1536 resolution), Print 2M - Med. (1600x1200
resolution), Print 1.3M - Small (1280x960
resolution), or MMS 0.3M (640x480 resolution).
• The image counter (4) displays the estimated number
of images you can capture using the current image
quality setting and memory in use (the counter is not
displayed during focus and image capture).
• The device memory ( ) and memory card ( )
indicators (5) show where images are saved.
Tip! Select Options > Turn icons on to display all
viewfinder indicators or Turn icons off to display
only the camera status indicators.
When taking a picture, note the following:
• Use both hands to keep the camera still.
• The quality of a digitally zoomed picture is lower than
that of a nonzoomed picture.
• The camera goes into the battery saving mode if there
are no keypresses for a moment. To continue taking
pictures, press .
After you take the picture, select the following from the toolbar:
• If you do not want to keep the image, select Delete.
• To send the video using multimedia, e-mail, Bluetooth,
or infrared, press the call key, or select Send.
• To capture a new image, select New image.
• To print the picture, select Print. See "Image print", on
page 37.
Still image camera settings
There are two kinds of settings for the still image camera:
Image setup and main settings. To adjust Image setup, see
"Setup settings — Adjust color and lighting", on page 26.
The setup settings return to the default settings after you
close the camera, but the main settings remain the same
until you change them again. To change the main settings,
select Options > Settings and from the following:
9247229_N93-1_en_Apac.book Page 24 Thursday, May 18, 2006 3:43 PM