Copyright
©
2006 Nokia. All rights reserved.
Tools
106
Select the desired barring option, and set it on (Activate)
or off (Cancel), or check whether the option is active (Check
status). Call barring affects all calls, including data calls.
Call barring and call diverting cannot be active at the
same time.
When calls are barred, calls may be possible to the official
emergency number programmed into your device.
Network
Your device can automatically switch between the GSM
and UMTS networks. The GSM network is indicated with
in the standby mode. The UMTS network is indicated
with .
Network mode (shown only if supported by the operator) —
Select which network to use. If you select Dual mode, the
device uses the GSM or UMTS network automatically,
according to the network parameters and the roaming
agreements between the network operators. Contact your
network operator for more details.
Operator selection — Select Automatic to set the device
to search for and select one of the available networks, or
Manual to manually select the network from a list of
networks. If the connection to the manually selected
network is lost, the device sounds an error tone and asks
you to reselect a network. The selected network must have
a roaming agreement with your home network, that is, the
operator whose SIM card is in your device.
Glossary: A roaming agreement is an agreement
between two or more network service providers to
enable the users of one service provider to use the
services of other service providers.
Cell info display — Select On to set the device to indicate
when it is used in a cellular network based on microcellular
network (MCN) technology and to activate cell info reception.
Enhanc. sett.
In the standby mode, indicates a compatible headset
is connected, and that the headset is unavailable, or a
Bluetooth connection to a headset is lost. indicates a
compatible loopset is connected and that a Text
phone is connected.
Select Headset, Loopset, Text phone, Bluetooth handsfree,
Music stand or Car kit stand and from the following:
Default profile — Set the profile that you want activated
each time you connect a certain enhancement to your
device. See "Profiles — set tones", on page 93.
Automatic answer — Set if you want the device to answer
an incoming call automatically after 5 seconds. If the ringing
9247229_N93-1_en_Apac.book Page 106 Thursday, May 18, 2006 3:43 PM
To Next Page
Loading...
