Hardware requirements for auto tuning:
• PC (Windows 2000/NT) with GPIB card
• Power supply
• Product specific module jig
• Cables: 3 (alt.1) RF cable, 1 GPIB cable and DAU-9S
• Signal analyser (TX), signal generator (RX) and RF-splitter
or
one device including all.
Figure 33 Auto tuning concept with CMU200
Figure 34 Auto tuning concept with RX and TX tuning devices and splitter
Copy the two phone specific ini-files, for example
rm_13_tunings.ini
and
autotune_RM-13.ini,
to a phone
specific folder, for example
\Phoenix\products\RM-13\
.
Steps
1. Make sure the phone (in the jig) is connected to the equipment. Else, some menus will not be shown in
Phoenix.
2. The first time you are using automatic tuning on this phone model, on this computer, you will have to
Set loss
for cables and jigs.
3. To go to autotune, select
Tuning (Alt-U)
>
Auto-Tune (Alt-A)
from the menu.
4. If you need more assistance, please refer to the Phoenix
Help
.
RM-305; RM-306
RF troubleshooting
Page 5 –8 COMPANY CONFIDENTIAL Issue 2
Copyright © 2007 Nokia. All rights reserved.
To Next Page
Loading...
