Pay attention to the items below after using the device
especially under salty water:
1. Wash the system box, shaft and the coil of the FINDX
Pro with tap water and be sure no salt water is left in
the connectors.
2. Do not use any chemicals for cleaning and/or for any
other purposes.
3. Wipe the screen and the shaft dry with a soft,
nonscratch cloth.
IMPORTANT! Wash the search coil only in the
FINDX version, the other parts of the device are not
waterproof!
CHECK COIL ICON
It indicates an interruption in the search coil transmitter
signal. The search coil connector may be unattached,
loose or disconnected. If you own another detector with
the same coil connector, please be sure that you have
not attached the wrong coil by mistake. If none of the
above exists, the search coil or its cable may have a
defect. If the issue continues when you change the
search coil, there may be an issue in the coil control
circuit.
5
5
16
CONTENTS
To Next Page
Loading...
Need help?
General
