QUICK GUIDE
1)
Assemble the device as per the instructions on page 2.
2) Press the Power & Mode Button once to turn on
the device.
3) When the device is turned on, it will start in the Field
mode. You can change the mode based on ground
conditions. For instance, if you are detecting on wet
beach sand, you may want to select the Beach mode.
You can find more details on search modes further in
this manual.
5
5
4) You can increase the sensitivity if needed. Increasing
the sensitivity will offer you greater depth. However, if
the surroundings or the ground cause excessive noise
in the device, you need to lower the sensitivity setting.
5
5
5) Testing the device with various metals would be
helpful for getting familiar with the sounds produced
by the device.
6) Use the Notch Discrimination setting to eliminate
unwanted metals from detection such as trash. Please
refer to the section titled Notch Discrimination in the
manual.
7
CONTENTS
To Next Page
Loading...
Need help?
General
