Backlight
It enables you to adjust the display brightness and the
keypad backlight level according to your personal
preference. It works in 3 different ways: Off, continuous
lighting, and automatic lighting. You can adjust the brightness
with the LCD Display & Keypad Backlight button.
5
5
It ranges from 0-5 and 6A-10A. At level 0, the display and keypad
backlight are off. Between 1-5, it remains continuously on. When
set between 6A-10A, it lights up only for a short period when a
target is detected or a button is pressed, and then it turns off.
5
6 A
To switch from continuous lighting to automatic lighting level,
just keep pressing the LCD Display & Keypad Backlight button.
The continuous operation of the backlight will affect power
consumption, which is not recommended.
The backlight setting is restored to the final saved setting when
the device is turned off and on again. This setting is common in
all modes; change made in any mode also applies to the other
modes.
PINPOINT
Pinpoint is to find the center or the exact location
of a detected target.
FINDX is a motion detector. In other words, you are
required to move the search coil over the target or the
target over the search coil in order for the device to
detect the target. The pinpoint mode is a non-motion
mode. The device continues to give a signal when the
search coil is kept stationary over the target.
When the pinpoint button is pressed and held down,
a graphics consisting of a dot surrounded by 4 circles
will appear in the middle of the screen. As the target is
approached, the circles will disappear one by one and
when the center of the target is reached, only the dot
will be left on screen. In the pinpoint mode, the signal
tone increases in pitch and volume as the search coil
approaches the target. In this mode, the device does
not discriminate or give target IDs.
To perform pinpoint:
1) After a target is detected, move the search coil
aside where there is no target response and push the
pinpoint button.
5
5
2) Keep the button pressed down and bring the search
coil closer to the target slowly and parallel to the
ground.
14
CONTENTS
To Next Page
Loading...
