Nolan n-com bluetooth kit 2.1

To Next Page

To Previous Page

3. INSTALLATION

YOU CAN DOWNLOAD THE VIDEO INSTRUCTIONS FROM THE WEBSITE http://www.n-com.it/en/n-

com/downloads.html

Warning: In order to use the N-Com Bluetooth Kit2 system, the Nolan helmet must be equipped with the

Basic Kit (or Basic Kit2), sold separately.

N.B.: Before using the N-Com Bluetooth Kit2 system, the battery must be installed and recharged (see

chapter 13)

Fig. 1

Fig. 2

Fig. 3

• Install the Basic Kit (or Basic Kit2) on the

helmet, according to the specific instructions

• After assembling the Basic Kit on the inside of

the helmet, apply the adhesive sealing gasket

around the connector as follows:

• Remove the N-Com protection plate from

the helmet (Fig. 1).

• Peel off the protective film from the

gasket.

• Apply the gasket around the connector as

shown in Fig. 2 and 3