Norac UC7 - Software Setup

WWW.NORAC.CA
PRECISIONDEFINED


Page29
Visitwww.solutions.norac.caformoresystem
installationandtroubleshootinginfo.
9  SoftwareSetup
1. Start up the sprayer and test the sprayer’s functionality.The display terminal does not need to be
poweredonfortheoriginalboomfunctionswitchestooperate.Unfoldtheboomsandraise/lowereach
boomandthemainsection.

Confirmthatthecablingandhosesdonotpinch,stretchorbindovertheentirerangeofmotion.
2. If any functions do not work, review the hydraulic and electrical portions of this manual to check for
properinstallation.
3. Turnonthepowerforthedisplayterminalusingtheswitchontheside.
4. TheprocedurefortheinstallationoftheUC7™BoomHeightControlsystemisnowcomplete.Beginthe
AutomaticSystemSetupprocedureasdescribedintheUC7TechnicalOperationManual.

