Owner’s Manual 10
Refrigerator Maintenance
Gas ame appearance:
While operating in propane gas mode, examine the appearance of the gas ame:
- Push and turn the gas control to the “HI” position.
- Open the lower intake vent.
The burner box cover can be hot. Wear gloves to avoid burns.
- Open the burner box door [165] and look at the gas ame [75] (See Art00955 and
Art02536).
The ame should be:
- a darker blue color on the inside of the ame and a lighter blue color on the
outside of the ame.
- a constant shape without ickering.
- Contact your dealer or Norcold authorized service center if the ame is:
- yellow
- ickering or changing shape.
- If the ame is yellow or has an erratic and unstable shape, contact your dealer
or Norcold authorized service center.
- Make sure the ame does not touch the inside of the ue tube [76].
- If the ame touches the inside of the ue tube, contact your dealer or Norcold
authorized service center.
- Close the burner box door.
Remove and clean the burner orice:
Your dealer or Norcold authorized service center must do this procedure.
To remove and clean the burner orice:
- Close the valve at the gas tank(s).
- Push and turn the gas control to the off ( ) position.
- Turn the selector switch to the OFF position ( ).
- Open the lower intake vent.
The burner box cover can be hot. Wear gloves to avoid burns.
- Remove the burner box cover by removing one screw.
To avoid possible propane gas leaks, always use two wrenches
to loosen and tighten the gas supply line at the refrigerator’s
manual shut off valve.
- Remove the are nut from the orice assembly [77] (See Art00956).
75
76
Art00955
167
Art 00956
77
78
79
80
CAUTION
!
NOTICE
CAUTION
!
WARNING
!
165
ART 02536