Owner’s Manual 12
Reinstall the Refrigerator
Your dealer or Norcold authorized service center must do this procedure.
Make sure the combustion seal is not broken, is completely around the refrigerator mounting anges, and
is between the mounting anges and the wall of the enclosure. If the combustion seal is not complete,
exhaust fumes can be present in the living area of the vehicle. The breathing of exhaust fumes can cause
dizziness, nausea, and in extreme cases, death.
1. Push the refrigerator completely into the enclosure.
2. Remove the door from the refrigerator.
3. Put the screws though the mounting anges and into the wall.
4. Put the plastic plugs into the mounting anges of the refrigerator.
5. Attach the door to the refrigerator
The rear of the refrigerator has sharp edges and corners. To prevent cuts or abrasions when working on the
refrigerator, be careful and wear cut resistant gloves.
6. Open the lower intake vent and put the screws through refrigerator and into the oor.
To avoid possible propane gas leaks, always use two wrenches to loosen and tighten the gas supply line at
the refrigerator’s manual shut off valve.
7. Attach the gas supply line to the 3/8 inch male are tting of the refrigerator.
8. Open the valve at the gas tank(s).
Do not allow the leak checking solution to touch the electrical components. Many liquids are electrically
conductive and can cause a shock hazard,electrical shorts, and in some cases re.
9. Examine the gas supply line for leaks.
10. Connect the DC wiring to the refrigerator:
- Install the DC fuse or connect the DC wiring to the battery or the converter.
- Connect the DC wires to the refrigerator.
11. Connect the AC power cord to the receptacle.
Replacement Parts
You may purchase replacement parts through your local RV dealer or authorized Norcold Service Center.
NOTICE
WARNING
!
WARNING
!
WARNING
!
CAUTION
!
To Next Page
Loading...
