Norcold N305X - Remove the Refrigerator

Owner’s Manual 11
Remove the Refrigerator
Your dealer or Norcold authorized service center must do this procedure.
The rear of the refrigerator has sharp edges and corners. To prevent cuts or abrasions when working on the
refrigerator, be careful and wear cut resistant gloves.
1. Close the valve at the gas tank(s).
To avoid possible propane gas leaks, always use two wrenches to loosen and tighten the gas supply line at
the refrigerator’s manual shut off valve.
2. Open the lower intake vent and remove the gas supply line from the 3/8 inch male are tting of the refrigerator.
3. Remove the AC power cord from the receptacle.
4. Remove the DC wiring from the refrigerator:
- Remove the DC wiring from the battery or the converter of the vehicle.
- Put a mark on the DC wires so you can put them back in the correct location.
- Remove the DC wires from the refrigerator.
5. Remove the screws which fasten the refrigerator to the oor.
6. Remove the plastic plugs from the mounting anges of the refrigerator.
7. Remove the door from the refrigerator.
8. Remove the screws which fasten the refrigerator to the wall.
9. Remove the refrigerator from the opening.
10. Attach the door to the refrigerator.
- Remove the orice assembly from the burner [78].
Do not try to remove the orice [79] from the orice adapter [80] when cleaning. Removal will damage
the orice and seal of the orice and can cause a propane gas leak. Leaking propane gas can ignite or
explode which can result in dangerous personal injury or death. Do not clean the orice with a pin or
other objects.
- Clean the orice assembly with air pressure and alcohol only.
- Using a wrench, assemble the orice assembly to the the burner.
- Assemble the are nut to the orice assembly.
- Tighten the are nut by hand.
- Hold the orice assembly securely and, using a wrench, tighten the are nut 1/4 revolution only.
- Examine all of the connections for gas leaks.
WARNING
!
WARNING
!
NOTICE
CAUTION
!