2
Product information
These compact units come in three models; CU-350, CU-450 and CU-900, with varying capacity
depending on the size of the cold room. They are for installation in recesses/holes in the wall
of a cold room. The units have a ‘cold side’ – the element which projects into the cold room and a
‘warm side’ – the element which projects from the outside of the cold room.
They are designed for chilling food for use in private households. The correct temperature in the
cold room will depend on correct construction and insulation. Leave the refrigeration unit inactive
after installation for approx. 2 hours before connecting to the mains electricity. This will allow the
oil to run back into the compressor after transport and installation. If it has been stored in sub-
zero temperatures, allow to stand for 24 hours at room temperature before starting.
There must be an adequate distance to the ceiling over the unit on the warm side to allow
disposal of the hot air produced. The units require a power supply of 220-240VAC 50 Hz and must
be connected to an earthed min.10A mains socket. If the power cable is not long enough (2.4-2.7m
mains cable connected to warm side), call an electrician to install an extra min.10A earthed socket.
If the unit does not start as soon as it is plugged in, it will start after a delay of up to 7 minutes.
In the event of full load or frequent door opening/closing, the compressor will run longer and it will
take longer to reach the desired room temperature. Keep the door closed as much as possible.
Ambient temperature on the warm side outside the cold room must always be higher than inside
but must not exceed an average temperature of 27 °C.
Scandinavian Appliances AS also supplies other products that you need for a self-build cold room.
We can offer two different cold room doors; the D-2000 with a fixed frame which can be white or
match the rest of the kitchen, and the D-1900, which is an externally-mounted white door. We also
stock fixture packs of wire shelves of various lengths, baskets and wine racks, plus shelf rails and
rests.
Important information
Scandinavian Appliances AS consumer products are sold for normal use in private households.
To ensure correct installation and use and thus maximise product lifetime, please read these
instructions carefully before starting installation. The manufacturer cannot be held liable
for damage caused through failure to follow the instructions below. The product will require
maintenance even in normal use, plus replacement of components which can wear out. These are
not covered during the warranty period, but are covered by the guarantee in accordance with the
Sale of Goods Act.
Electrical safety for the appliance is only guaranteed if the earthing system in the house has been
installed correctly and that the voltage is as specified above. Never allow the unit to be connected
to an extension lead permanently. The mains socket must be easily accessible for installation/
service. Disconnect plug when cleaning. Other authorities can apply regulations for e.g. lighting,
alarm and the like with regard to installation. Repairs must only be made by qualified personnel.
The appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Data plate with serial number is located behind the front cover on the warm side. Serial number
must always be stated when contacting service contractor or manufacturer. Scandinavian
Appliances AS cannot be held liable for any printing errors in these user instructions and reserves
the right to change product specifications.
To Next Page
Loading...