Need help?Do you have a question about the Nord Drivesystems NORDAC FLEX SK 205E Series and is the answer not in the manual?
General| Series | NORDAC FLEX SK 205E |
|---|---|
| Category | Inverter |
| Protection Class | IP20 |
| Braking Resistor | Optional |
| Power Range | 0.25 to 22 kW |
| Input Voltage | 3 × 380 – 480 V |
| Output Voltage | Three-phase 0 to input voltage |
| Control Mode | V/f control, vector control |
| Communication Interfaces | RS485, CANopen, PROFIBUS |
| Frequency Range | 0 to 600 Hz |
| Cooling Method | Natural convection |
| Ambient Temperature Range | -10 °C to +40 °C |
| Storage Temperature Range | -25 °C to +70 °C |
| Relative Humidity | 95% (non-condensing) |
| Installation Altitude | Up to 1000 m |
Crucial safety instructions, general precautions, and requirements for qualified personnel.
Information on warning symbols used on the product and in the documentation.
Information on mounting devices on motor terminal boxes or in their vicinity.
Explains the function and use of braking resistors for dynamic braking.
General guidelines and specific connections for power and control units.
Safety precautions and requirements for operating devices in ATEX and EAC Ex environments.
Explains the default pre-programmed settings for standard applications.
Guides on choosing the correct motor control mode (ASM or PMSM) for optimal performance.
Describes various methods for commissioning the frequency inverter.
Details the AS interface bus system, its principles, and device-specific information.
Provides a comprehensive list of all parameters, categorized by function.
Details how parameters are displayed and organized, including array levels.
How operating status messages are displayed via LEDs, SimpleBox, and ParameterBox.
Lists and explains various error and warning messages generated by the device.
To Next Page
