5.9 Overview of Parameters, User-defined Settings
BU 0200 GB Subject to technical alterations 147
Parameter Nr.
[Array]
Name
Factory
setting
Super
visor
Setting after commissioning
P 1 P 2 P 3 P 4
P533 Factor I
2
t-Motor [%] 100 S
P534 [01] (P)
Torque-based disconn.
Limit [%]
401 (off) S
P534 [02] (P)
Torque-based disconn.
Limit [%]
401 (off) S
P535 I
2
t motor 0
P536 Current limit 1.5 S
P537 Pulse switch-off [%] 150 S
P539 (P) Output monitoring 0 S
P540 (P) Rotation direction mode 0 S
P541 Set relay [hex] 0000 S
P542 Set analog output [V] 0.0 S
P543 [01] (P) Actual bus value 1 1 S
P543 [02] (P) Actual bus value 2 4 S
P543 [03] (P) Actual bus value 3 9 S
P546 [01] (P) Function Bus setpoint 1 1 S
P546 [02] (P) Function Bus setpoint 2 0 S
P546 [03] (P) Function Bus setpoint 3 0 S
P549 PotentiometerBox function 0 S
P552 [01] CAN master cycle [ms] 0 S
P552 [02] CAN master cycle [ms] 0 S
P554
Min. chopper trigger point
[%]
65 S
P555 P chopper limit [%] 100 S
P556 Braking resistance [Ω] 120 S
P557
Braking resistance power
[kW] [kW]
0 S
P558 (P) Magnetisation time [ms] 1 S
P559 (P) DC run-on time [s] 0.50 S
P560 Store in EEPROM 1 S
POSITIONING (5.7) NOTE: Further details are listed and described in Manual BU 0210.
(www.nord.com)
P600 (P) Position control 0 (off) S
P601 Actual position [rev] --- S
P602 Actual Ref. Pos. [rev] --- S
P603 Curr. position. diff. [rev] --- S
P604 Encoder type 0 S
P605 [01]
Absolute value encoder
(multi)
10 S
P605 [02]
Absolute value encoder
(single)
10 S
P607 [01] Ratio (increment) 1 S
P607 [02] Ratio (absolute) 1 S
To Next Page
Loading...
