Nordic AirPatrol

6 7
Buttons
Use a straightened paper clip or something similar to push the recessed
buttons.
RESET button
Short push turns the controller off when working on battery
AirPatrol has a battery that keeps it operational even if it’s disconnected
from a wall outlet. To fully turn off the controller, push the RESET button.
The 3 LED lights will blink for about a second and the controller switches
off.
Use this button also to clear the most recent settings (the Owner number
will remain unchanged).
TEST button
Short push turns the heat pump ON/OFF.
Use the TEST button to confirm that the IR beam from the controller
reaches the heat pump.
NB! Pushing both
buttons simultaneously
for 3 seconds initiates
the hard reset: restores
factory settings, deletes
Owner number and
heat pump settings
(same function as with
command SMS “90”).
A) Make sure that you
have previously disabled
the SIM card PIN code.
Insert SIM card as shown
into AirPatrol.
B) Plug the adapter into
the socket under the
AirPatrol.
Power
When the power is out (power = 0V) the controller continues to work on
the battery and turns off after the battery’s voltage drops below 3.5V.
A fresh battery lasts for approximately 24 hours (note that over time
the battery’s capacity decreases). After the controller is turned off the
run time will be saved. To save battery life when the power is out the
controller can be turned off with a short push on the RESET button.
SIM card
NB!
Make sure you disable the PIN code of the SIM card you use in
AirPatrol.
NB! Make sure the SIM card you use in AirPatrol can access 2G network.
AirPatrol is not compatible with SIM cards that use only 3G network.
AirPatrol not responding:
1) Check your GSM network signal strength, it may be too weak in your
selected location.
2) Prepaid SIM-cards can run out of money or expire within 6-12 months
if not recharged