Nordic AirPatrol

12 13
MIN
NORM
MAX
(AUTO)
AUTO
DRY
COOL
HEAT
T8, T9, T10
16
18
...
28
30
Combine the pump mode, room temperature and fan speed values for a
home atmosphere you like the best.
Commands
The range of heat pump temperature values AirPatrol controls is 16-30
°C (default +20 °C) and the fan speeds are AUTO, MIN, NORM, MAX
(the default is NORM).
After selecting a mode (AUTO, DRY, COOL, HEAT, T8) heat pump is
turned on with 20 °C maximum temperature and normal fan speed, if not
assigned differently by the Owner or the Users.
The pump can be assigned different temperature and fan speed values
with AirPatrol.
For example, the SMS: “COOL 19 MAX” orders the pump to cool until 19
°C and fan at maximum speed. When you change a heat pump function
AirPatrol always responds with an SMS that reports its STATUS.
User levels
The amount of control AirPatrol users have over the device and the
amount of information they receive from the device can be set on a 3
level scale:
1. The
Owner can send commands, report queries, setup commands and
receive AirPatrol report messages and alarm messages.
2. The
Users can send commands and report queries to AirPatrol but
cannot send Setup commands.
3. The
All-level users can make report queries about the status of the
controller.