Turn on the fan if desired.
To turn on the fan at low
speed, press the ,_,, odo,,,e_,
AutoBreeze Fans button;
the word "Fan" and the
number 1 wHUappear in
the dispUay, To turn on
the fan at medium speed, press the button a sec-
ond time; the number 2 wHUappear in the dispUay,
To turn on the fan at high speed, press the button
a third time; the number 3 wHUappear in the dis-
pUay,To seUectthe auto mode, press the button
again; the word "Auto" wHUappear in the dispUay,
When the auto mode is seUected, the speed of the
fan wHUautomatically increase and decrease as
the speed of the waUkingbeUtincreases and de-
creases,
To turn off the fan, press the AutoBreeze Fan but-
ton again, Note: A few minutes after the walking
belt is stopped, the fan will automatically turn off,
When you are finished exercising, remove the
key.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the Jowest
setting, The incline must be at the lowest setting
when the treadmill is fotded to the storage posi-
tion or the treadmill will be damaged, Next, re-
move the key from the console and put it in a se-
cure place, Note: if the display remains lit after
the key is removed, the console is in the
"demo" mode, See page 23 and turn off the
demo mode,
When you are finished using the treadmill, switch
the reset/off circuit breaker to the off position and
unplug the power cord,
14
To Next Page
Loading...
