14
14
14. Raise the Frame (56) to the upright position.
Have a second person hold the Frame until
step 16 is completed.
Orient the Latch Crossbar (41) as shown. Make
sure that the “This side toward belt” sticker
(H) is facing the treadmill. Attach the Latch
Crossbar to the brackets on the Frame (56) with
two 5/16" x 3/4" Screws (6) and two 5/16" Star
Washers (11).
56
41
H
6
Brackets
11
94
95
23
34
I
15
15. Remove the 5/16" Nut (34) and the 5/16" x 1 3/4"
Bolt (23) from the bracket on the Base (94).
Next, orient the Storage Latch (95) as shown.
Attach the lower end of the Storage Latch (95)
to the bracket on the Base (94) with the 5/16" x
1 3/4" Bolt (23) and the 5/16" Nut (34).
Then, raise the Storage Latch (95) to a vertical
position, and remove the tie (I).
6
11
To Next Page
Loading...
