14
14. Attach the Tray (88) to the Upright Crossbar
(89) with four #8 x 1/2" Screws (2); start all four
Screws, and then tighten them. Do not over-
tighten the Screws.
14
2
89
2
88
15
15. Note: If the treadmill is assembled on a
smooth surface, it may roll forward in this
step.
Remove the two 5/16" x 3/4" Patch Screws (40)
from the Latch Crossbar (55). Note: The Latch
Crossbar is not preattached to the Frame (59).
Next, raise the Frame (59) to the upright posi-
tion. Have a second person hold the Frame
until step 17 is completed.
Orient the Latch Crossbar (55) as shown. Make
sure that the “This side toward belt” sticker
(K) is facing the treadmill. Attach the Latch
Crossbar to the brackets (L) on the Frame
(59) with the two 5/16" x 3/4" Patch Screws
(40) that you just removed and two 5/16" Star
Washers (12).
59
55
K
L
L
40
40
12
12
To Next Page
Loading...
