NordicTrack FUSION CST STUDIO - ATTACHING TABLET HOLDER; PLUGGING IN POWER ADAPTER

10
7
7. Plug the Power Adapter (126) into the receptacle
on the rear of the strength system.
Note: To plug the Power Adapter (126) into an
outlet, see HOW TO PLUG IN THE POWER
ADAPTER on page 11.
8. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
HOW TO USE THE STRENGTH SYSTEM on page 11.
Before using the strength system, pull each handle a few times to make sure that the ropes move smoothly
around the pulleys. If one of the ropes does not move smoothly, find and correct the problem.
To register your product and activate your warranty today, go to my.nordictrack.com.
126
6
6. The magnetic Tablet Holder (68) can be attached
at any height on the Mirror (59).
Orient the Tablet Holder (68) so that the slot
(B) is facing upward and the padded side (C) is
facing the Mirror (59).
IMPORTANT: Always hold the Tablet Holder
(68) in the horizontal position when attaching
it to the Mirror (59).
Attach the Tablet Holder (68) to the Mirror (59)
at the desired height. Make sure that the Tablet
Holder is level and centered on the Mirror.
Set the Tablet (40) in the Tablet Holder (68).
68
B
C
40
59