3. Press three 2Ó Square Inner Caps (28) into the
Butterfly Upright (1).
Place the bracket on the lower end of the Butterfly
Upright (1) over the indicated 5/16Ó x 2 1/2Ó Carriage
Bolts (92) in the Butterfly Base (4). Hand tighten two
5/16Ó Nylon Locknuts (64) onto the Bolts.
Thread an Adjustment Handle (85) into the indicated
hole in the Butterfly Upright (1).
3
6
4. Press a 2Ó Square Inner Cap (28) into the Weight
Upright (9).
Place the bracket on the lower end of the Weight
Upright (9) over the indicated 5/16Ó x 2 1/2Ó Carriage
Bolts (92) in the Weight Base (5). Hand tighten two
5/16Ó Nylon Locknuts (64) onto the Bolts.
4
64
64
9
1
28
28
28
85
4
92
28
92
5
64
To Next Page
Loading...
