NordicTrack Grt470 - Page 7

5. Press two 2Ó Square Inner Caps (28) into the Press
Upright (2). Press a 1 3/4Ó Square Inner Cap (35) into
the welded tube on the Press Upright.
Place the bracket on the lower end of the Press
Upright (2) onto the indicated 5/16Ó x 2 1/2Ó Carriage
Bolts (92) and secure it with two 5/16Ó Nylon Locknuts
(64).
Thread an Adjustment Handle (85) into the indicated
hole in the Press Upright (2).
5
7
6. With a second person holding the Right Support
Frame (33) in position, attach the Right Support
Frame to the Butterfly Upright (1) with two 5/16Ó x 2
3/4Ó Bolts (89), two 5/16Ó Washers (36), and two 5/16Ó
Nylon Locknuts (64). Do not tighten the Nylon
Locknuts yet.
6
92
6
1
33
89
36
36
64
2
28
28
35
64
85
64
64
7. While a second person holds the Left Support Frame
(97) in position, attach the Left Support Frame to the
Press Upright (2) with two 5/16Ó x 2 3/4Ó Bolts (89),
two 5/16Ó Washers (36), and two 5/16Ó Nylon
Locknuts (64). Do not tighten the Nylon Locknuts
yet.
7
64
89
36
36
97
2