To Next PageTo Next PageWhat to do if my NordicTrack Treadmill power turns off during use?
If the power on your NordicTrack Treadmill turns off during use: Check the power switch. If it has tripped, wait five minutes, then press it back in. Also, ensure the power cord is plugged in. If it is, unplug it, wait five minutes, and then plug it back in.
How to fix a NordicTrack Incline Trainer X11 Treadmill if the power does not turn on?
If your NordicTrack Treadmill does not turn on, ensure the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet. Use only a surge suppressor that meets the specifications described on page 14. After plugging in the power cord, make sure the key is inserted into the console. Also, check the power switch located on the frame near the power cord. If the switch protrudes, it has tripped. To reset it, wait five minutes and then press the switch back in.
Why does the NordicTrack Incline Trainer X11 walking belt slow down when I walk on it?
If your NordicTrack Treadmill's walking belt slows down when you walk on it, ensure you are using a surge suppressor that meets the specifications described on page 14. Also, if the walking belt is overtightened, it can decrease performance and damage the belt. To correct this, first, adjust the incline to 40 percent. Remove the key and unplug the power cord. Use a hex key to turn both idler roller screws counterclockwise 1/4 of a turn. When the belt is properly tightened, you should be able to lift each edge 3 to 4 inches off the platform. Keep the belt centered. Plug the power cord back in, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
General| Speed Range | 0-12 MPH |
|---|---|
| Running Area | 22" x 60" |
| Display | 10" Smart HD Touchscreen |
| Weight Capacity | 300 lbs |
| Folding | No |
| Bluetooth | Yes |
| Cooling Fan | Yes |
| Audio | Dual 2" Speakers |
| Incline | -6% to 40% |
| Programs | iFit Enabled |
Warning to keep extremities clear of moving parts during operation.
General safety warning to read manual and follow instructions before use.
Consult physician, ensure safe environment, and respect user limits.
Use surge protectors, unplug safely, and understand emergency stop.
Install console, crossbar, handrails, and console covers.
Proper connection of the power cord using a surge suppressor.
Steps for starting the belt and controlling speed/incline.
Troubleshooting power on/off problems and demo mode behavior.
Diagnosing and correcting walking belt slowing or slipping problems.
