To Next PageTo Next PageWhat to do if the NordicTrack X9i incline trainer NTL19010.0 power turns off during use?
If the power turns off during use, first check the power switch. If the switch has tripped, wait for five minutes, and then press it back in. Also, ensure that the power cord is properly plugged in. If it is, unplug it, wait five minutes, and then plug it back in.
How to troubleshoot a NordicTrack X9i incline trainer NTL19010.0 that does not turn on?
To address the issue of the NordicTrack Treadmill not powering on, ensure the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly-grounded outlet. Use only a single-outlet surge suppressor. Also, after plugging in the power cord, verify that the key is inserted into the console. Finally, check the power switch located on the incline trainer frame near the power cord. If the switch protrudes, it has tripped. To reset it, wait five minutes and then press the switch back in.
What to do if NordicTrack X9i incline trainer NTL19010.0 Treadmill console does not display speed and distance correctly?
If the NordicTrack Treadmill console does not display speed and distance correctly, remove the key and unplug the power cord. Remove the three indicated #8 x 1/2" Cover Screws and the #8 x 1 1/4" Screw, then lift off the Left Roller Cover. Locate the Reed Switch and the Magnet on the left side of the Pulley. Turn the Pulley until the Magnet is aligned with the Reed Switch, ensuring the gap between them is about 1/8 in. (3 mm). If needed, loosen the #8 x 3/4" Clamp Screw, move the Reed Switch slightly, and retighten the Screw. Reattach the Left Roller Cover and run the incline trainer for a few minutes to check for a correct speed reading.
How to fix a NordicTrack X9i incline trainer NTL19010.0 walking belt that is off-center or slips?
If your NordicTrack Treadmill walking belt is off-center, first, adjust the incline to 40 percent, remove the key, and unplug the power cord. If the belt has shifted left, use a hex key to turn the left idler roller screw clockwise 1/2 turn. If it has shifted right, turn the left idler roller screw counterclockwise 1/2 turn. If the walking belt slips when walked on, first adjust the incline to 40 percent, remove the key, and unplug the power cord. Then, using the hex key, turn both idler roller screws clockwise 1/4 of a turn.
General| Brand | NordicTrack |
|---|---|
| Model | X9i incline trainer NTL19010.0 |
| Category | Treadmill |
| Language | English |
Shows locations of warning decals and instructs to call for replacements.
Lists crucial safety and usage instructions for the incline trainer.
Provides instructions for assembling the incline trainer, requiring two people and specific tools.
Details the correct procedure for connecting the power cord and surge suppressor safely.
Guides users on properly powering on the incline trainer, including safety precautions.
Explains how to interact with the console's touch screen for navigation and input.
Details how to start the belt, adjust speed/incline, and monitor progress in manual mode.
Provides steps for logging into iFit Live and choosing available online workouts.
Details steps for enabling Wi-Fi, connecting to networks, and managing connections.
Provides detailed safety instructions and procedures for moving the incline trainer.
Solutions for the incline trainer failing to power on or turning off during use.
Guides on fixing incline problems and walking belt speed reduction issues.
