13
14. Make sure there is a piece of cardboard below
the rear of the Frame (56) and that the pieces of
foam have been removed from the indicated
areas.
Plug in the power cord (see page 15) and turn
on the power (see page 17). The incline system
will automatically calibrate and the Frame (56)
w
ill move up and down. If the incline system
does not automatically calibrate, manually cali-
brate the incline (see page 26).
Then, press the Incline increase button once.
When the Frame (56) stops moving, remove the
key from the console and unplug the power
cord.
56
14
Cardboard
Remove
Foam
15. Raise the Frame (56) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (53) so that the large
barrel and the latch knob are oriented as shown.
Attach the upper end of the Storage Latch (53)
to the bracket on the Frame (56) with a 3/8" x
1 3/4" Patch Bolt (6) and a 3/8" Nut (12).
Attach the lower end of the Storage Latch (53) to
the Base (94) with a 3/8" x 2" Bolt (3) and a 3/8"
Nut (12). Note: It may be necessary to move the
Frame (56) back and forth to align the Storage
Latch with the Base.
15
53
12
Large
Barrel
56
6
Latch
Knob
12
3
94
To Next Page
Loading...
