6
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you complete all assembly steps.
• To avoid damaging parts, do not use power tools.
• Assembly assembly requires the following tool(s):
one Phillips screwdriver
ASSEMBLY
2
2. Attach the tablet holder (D) to the base (B) with
two screws (E).
D
E
B
A
1
1. Plug the power adapter (A) into the receptacle
on the underside of the base (B). Route the wire
on the power adapter through the notch (C) in
the base.
Note: After you complete all assembly steps,
see HOW TO USE THE POWER ADAPTER on
page 8 to plug the power adapter (A) into
an outlet.
B
C
To Next Page
Loading...
