NordicTrack S27i - Page 10

10
9. Finish attaching the Console (10) with seven
M4 x 32mm Machine Screws (161) and seven
M4 Washers (162); start all the Machine
Screws, and then tighten them.
161
161
161
161
162
162
162
162
10
9
Note: This drawing is scaled to 94% compared to the
other assembly drawings and to the exploded drawing.
8
8. Note: For clarity, the Console and the wires
are not shown in the drawing.
Tilt the Console (not shown) upward and down-
ward a few times. If the movement feels too
loose, tighten the four M6 x 15mm Cap Screws
(157) in the Rear Bracket Mount (114) until the
movement no longer feels loose. Tip: Tilt the
Console upward and downward to access the
Cap Screws.
157
157
114