11
11
10
107
94
11. IMPORTANT: Have a second person move the
Console (10) from side to side, if necessary,
so that it is level. While the second person
holds the Console still, firmly tighten the
M10 x 52mm Screw (94).
Next, orient the Tray Top (38) and the Tray
Bottom (163) as shown and have a second
person hold them in place on the Console
Support (8).
Tip: Avoid pinching the wires (E, F). Attach
the Tray Top (38) and the Tray Bottom (163) to
the Console Support (8) with four M4 x 15mm
Machine Screws (107); start all the Machine
Screws, and then tighten them.
Avoid
pinching
the wires
(E, F)
8
38
163
E, F
10
10. Orient the Lower Console Cover (154) as
shown and press it onto the back of the Console
(10). Position the wires (not shown) in the
indicated notch (I).
Tip: Avoid pinching the wires. Orient the
Upper Console Cover (155) as shown and press
it onto the back of the Console (10).
155
154
I
10
Avoid pinching
the wires
To Next Page
Loading...
